EPEVER Photo voltaic CHARGE CONTROLLER Set up: TRACER AN SERIES CONTROLLE
EPEVER Photo voltaic CHARGE CONTROLLER Set up: TRACER AN SERIES CONTROLLE
Blog Article
The EPEVER Tracer AN Series Photo voltaic Demand Controller is really a highly economical solar controller created for off-grid photo voltaic units. Based on multiphase synchronous rectification engineering, it guarantees optimized Electricity conversion and process balance for a variety of photovoltaic (PV) apps.
Crucial Attributes of the EPEVER Tracer AN Sequence Controller
The Tracer AN collection utilizes EPEVER Solar Cost Controller know-how for superior solar Electricity harvesting. Important options contain:
Multiphase Synchronous Rectification (MSR) for enhanced Power conversion.
Sophisticated MPPT Algorithm with >ninety nine% effectiveness.
Twin-Phase Charging for Improved battery lifetime.
LCD Screen with authentic-time knowledge checking.
Numerous Load Command Modes like manual and timer.
In depth Electronic Protections from overcharging, around-discharging, limited circuits, and reverse polarity.
Step-by-Phase Guide to Putting together the EPEVER Tracer AN Series Controller
one. Unboxing and Getting ready the Controller
Make sure all parts are included: Tracer AN device, temperature sensor, communication cables, and consumer handbook.
Verify the product selection and voltage scores match your photo voltaic panel and battery technical specs.
two. Mounting the Charge Controller
Select a properly-ventilated, dry locale close to the battery bank.
Protected the Tracer AN controller using the delivered mounting brackets.
Preserve suitable clearance for warmth dissipation.
three. Wiring the Photo voltaic Cost Controller
Caution: Constantly observe proper safety protocols and ensure the program is driven off in advance of connecting factors.
Move one: Connect the battery terminals towards the charge controller (favourable to optimistic, detrimental to destructive).
Move 2: Connect the solar panel array for the PV enter terminals.
Action three: Hook up the load terminals if utilizing a direct load link.
Move 4: Double-check all connections for polarity and tightness.
4. Configuring the Controller Configurations
Power on the controller by connecting the battery first.
Utilize the Liquid crystal display Exhibit to navigate the options menu.
Configure:
Battery Variety: AGM, GEL, Flooded, Lithium.
Charging Parameters: Absorption voltage, float voltage.
Load Command Modes: Handbook, timer, gentle Handle.
five. Checking and Data Logging
The Tracer AN Collection supports authentic-time monitoring using the MT50 distant meter.
Facts is often logged through the RS485 conversation port employing software package for example Solar Station PC.
Remote monitoring can be done While using the EPEVER WiFi module.
six. Troubleshooting Typical Issues
Challenge 1: No Click Here Power Output
Look at battery voltage and connections.
Confirm PV panel voltage exceeds battery voltage.
Problem two: Above-Voltage Security
Confirm the solar array’s voltage score.
Adjust system parameters if required.
Issue three: No Battery Charging
Inspect PV wiring for continuity.
Confirm MPPT configurations inside the menu.
Great things about the Tracer AN Series with MSR Technology
The multiphase synchronous rectification know-how guarantees:
Better Effectiveness: Reduced Strength losses throughout conversion.
Improved Trustworthiness: Steady overall performance underneath variable loads.
For a longer time Battery Life: Steady and exact charging profiles.
Conclusion
The EPEVER Solar Cost Controller with multiphase synchronous rectification technology is undoubtedly an exceptional choice for optimizing solar power technology and increasing battery existence. By pursuing the above mentioned setup guidebook, end users can be certain optimum effectiveness and process longevity.